Vertical baler is mainly suitable for waste paper, plastic, straw, but also suitable for cottonseed, clothing, towels, blankets, fabrics, quilts, woven bags and other soft materials compression packaging.
1, packing pressure from 3 tons to 315 tons, specifications are complete
2, hydraulic drive, the use of upper cylinder
3. All cylinders adopt imported sealing rings.
1, before starting, check whether the appearance of the equipment is abnormal, whether there are security risks around, and whether the iron wire or plastic rope is sufficient. After confirming that it is normal, open the main air switch of the distribution box, pop out the emergency stop button, and the power indicator of the electric control box will light up.
2, remote control local gear selection switch to remote control gear.
3. Put the magnetic switch on the remote control into the card slot, press the system start button on the remote control twice, and stop warning the device is ready to run after the siren sounds for 10 seconds, and the red alarm light
is on.
4 Press the conveyor belt start button on the remote control, the conveyor belt runs, push the paper or other materials into the conveyor into the material port, and the conveyor belt will bring the material into the packaging entrance.
5. After the paper or other materials arrive at the location, press the compression button on the remote control, the red alarm light flashes, and the press head will automatically retreat and stop after the press head is in place (if the press head moves forward to a certain position after the compression starts, it will not move or stop and will automatically return to the return position after tens of seconds, the siren will alarm at a frequency of 1 second when returning, then the automatic alarm arm type will click the remote control to loosen the arm, so that the arm will be released. Start compression again until normal no longer alarm. The manual report arm type is pressed on bothsides of the arm with a jack, the screws on both sides rotate equidistance into some, and then start compression until it is normal and does not alarm).
6 Repeat operation 4, until the important packing length, press the bale button on the remote control for 2 seconds, the device will automatically start, the press head will stop when it moves forward to the front bale position, and
the siren will alarm at a frequency of 3 seconds after it is in place.
7, press the wire button on the remote control, the wire machine will automatically thread the wire or plastic rope into, the wire machine will automatically return to the original position.
8, tie the wire or rope and cut it, and the package ends.
9 Repeat the above 4-8 procedures of the bag mouth will be rolled out one bag after another, with a truck or forklift to move the finished bag to the appropriate place to put neatly.
10. After the work is completed, press the stop button of the remote control system, take down the magnetic switch, press the emergency stop switch of the electric control box, and turn off the total power supply.